EuroLite LED PST-9W RGB Bedienungsanleitung PDF herunterladen (Seite 13)

00058530.DOC, Version 1.3

13/15

5. SETUP

5.1 Installation

Install the device on a plane surface or at the wall.

Attachment

Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times

the device's weight.

The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant

location. Make sure that the device is installed absolutely planar by using a water-level.

The device must be installed out of the reach of people.

The device must always be installed via all fixation holes. Do only use appropriate screws and make sure

that the screws are properly connected with the ground.

The durability of the installation depends very much on the material used at the installation area (building

material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to

suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum

load and the building material.

Procedure:

Step 1: The holes for the installation are on the baseplate.

Step 2: Hold the baseplate onto the location where the device is to be installed.

Step 3: Mark the boreholes with a pen or a suitable tool.

Step 4: Drill the holes.

Step 5: Hold the baseplate in the desired position and tighten it.

DANGERTOLIFE!

Beforetakingintooperationforthefirsttime,theinstallationhastobeapprovedbyanexpert!

5.2 Sound-control

The sound-control works via the built-in microphone.

5.3 DMX-Connection between the devices

The wires must not come into contact with each other, otherwise

the fixtures will not work at all, or will not work properly.

Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with

the fixture or one fixture with another.

Building a serial DMX-chain:

Connect the DMX-output of the DMX LED Operator IR2DMX with the DMX-input of the nearest device.

Always connect one output with the input of the next fixture until all fixtures are connected.

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120  resistor

between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

1 2 ... 8 9 10 11 12 13 14 15

Keine Kommentare

EuroLite LED PST-9W RGB Bedienungsanleitung Seite 13